ZyXEL Communications user manual Prestige 128MH WAN Port Setup, Note on WAN Setup

Prestige 128MH PSTN Router/Hub

2.8WAN Setup

This section describes how to configure the WAN ports on your Prestige 128MH by using Menu

2- WAN Setup. The Menu 2 - WAN Setup is used for entering information about your Modem or ISDN TA connected to the serial port WAN Port 1 and the modem line connected internally to WAN port 2 or 3 (LINE 1,2). Select a WAN Port (# 1,2, or3) that you wish to configure first. Then configure the WAN Port from Submenu 2.1. If advanced setup is required, go into Menu 2.2. When you are finished, press [Enter] in Menu 2.1. Your Prestige will save the information to ROM first; then use this information to initialize the Wan Port and the attached modem or ISDN TA.

Note on WAN Setup

Before you connect a leased line modem or ISDN TA to your Prestige, make sure to configure the device accordingly. To configure the modem or ISDN TA, refer to the instructions provided by the manufacturer

2.8.1Prestige 128MH WAN Port Setup

Prestige 128MH supports three WAN port connections with Modems or ISDN TAs.

To configure the WAN ports on Prestige 128MH, follow these steps:

Step 1. Select option [2. WAN Setup] in the Main Menu by typing 2 at the menu selection number prompt.

Step 2. In Menu 2 - WAN Port Setup, as shown in Figure 2-8, enter the number (1,2, or 3) of the WAN port you wish to configure.

•Select option [1. Wan Port 1(External)] to setup the WAN port 1 with external modem or ISDN TA parameters.

•Select options [2,3 Wan Port 2,3(Internal)] to configure the Internal 56K Modems on WAN Port 2 and 3.

2-14Chapter 2 Hardware Installation & Initial Setup