ZyXEL Communications 128MH user manual A Warning On Connection Cables, Connect the Serial WAN Port

Prestige 128MH PSTN Router/Hub

This section outlines how to connect your Prestige 128MH to the LAN and the WANs. Refer to Figure 1-2 to identify all of the ports on your device. Then see Figure 2-1 when you attempt to make the various connections.

Follow these steps designed to guide you through a quick and correct installation of your Prestige

128MH.

A Warning On Connection Cables

The SMT RS-232 cable, WAN modem line, and Ethernet cable are very similar to each other. It is important that you use the correct cable for each connection; otherwise, your Prestige could be damaged.

Step 1. Connect Your Computer and Your Prestige

For the initial setup and configuration of your Prestige 128MH, you must use RS-232 and communications software.

After your Prestige has been successfully installed, you can modify the configuration through a remote Telnet connection. See Chapter 12 - Telnet Configuration and Capabilities for detailed instructions on using Telnet to configure your Prestige 128MH.

Note on Connecting the RS-232 Cable to your Prestige

One RJ45 to RS-232 female adapter cable is included in your package. To make a RS-232 connection, first connect the RJ45 end of the cable to the CONSOLE port on the back panel of the Prestige. Connect the other end to the RS-232 cable attached to the serial port (COM1, COM2, or any other COM port) of your computer.

Step 2. Connect the Serial WAN Port

The Prestige 128MH has one serial WAN port (WAN port 1) which can be connected to a Dial-up modem, a Leased Line modem, or ISDN TA (Terminal Adapter). The serial WAN port uses a RJ45 connector. A cable is provided to convert RJ-45 to DB-25.

2-4Chapter 2 Hardware Installation & Initial Setup