ZyXEL Communications 128MH user manual Default Dial-In Setup for Bridge, Bridge Static Route Setup

Prestige 128MH PSTN Router/Hub

8.3.2 Default Dial-In Setup for Bridge

There is only one dial-in parameter [PPP Options: Recv. Authen] in Menu 13 - Default Dial-In Setup that you need to fill out for Bridging applications, as shown in Table 8-4.

Table 8-4. Default Dial-in Setup Field for Bridging Applications

Field

Description

(Menu 13)

PPP Options: Recv. Authen

Make sure this field is set to [Yes].

Once you have completed filling in this menu, press [Enter] at the message [Press Enter to Confirm] to save your selections, or press [Esc] to cancel your selection.

8.3.3 Bridge Static Route Setup

You can configure Bridge static routes for your Bridging applications in Menu 12.3, as shown in

Figure 8-3.

Menu 12.3 - Edit Bridge Static Route

Route #: 21

Route Name=

Active= No

Ether Address= ?

IP Address=

Gateway Node= 1

Press ENTER to CONFIRM or ESC to CANCEL:

Figure 8-3 Menu 12.3 - Edit Bridge Static Route

8-6Chapter 8 Bridge Configuration for LAN-to-LAN