ZyXEL Communications 128MH user manual Remote Node Setup

Prestige 128MH PSTN Router/Hub

7.5.1 Remote Node Setup

Follow the procedure in Chapter 5 to define the protocol-independent parameters in Menu 11.1 - Remote Node Profile. For the protocol-dependent parameters in Menu 11.3 - Remote Node Network Layer Options, follow the ensuing instructions. If your Prestige is configured to receive an incoming call, you can also configure the default dial-in parameters in Menu 13.

To edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 7-4, follow these steps:

Step 3. In Menu 11.1, make sure [IPX] is among the protocols in the Route field. (The Route field should display Route = IPX or Route = IP + IPX.)

Step 4. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and set the value to [Yes], and press [Enter] to edit Menu 11.3 - Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

IP Options:	IPX Options:
Rem IP Addr:	Dial-On-Query= No
Rem Subnet Mask= N/A	Rem LAN Net #= 00000000
My WAN Addr= N/A	My WAN Net #= 00000000
Single User Account= N/A	Hop Count= 1
Server IP Addr= N/A	Tick Count= 2
Metric= N/A	W/D Spoofing(min)= 3
Private= N/A	SAP/RIP Timeout(min)= 3
RIP Direction= N/A
Version= N/A	Bridge Options:
	Dial-On-Broadcast= N/A
	Ethernet Addr Timeout(min)= N/A

Enter here to CONFIRM or ESC to CANCEL:

Figure 7-4. Menu 11.3 - Remote Node Network Layer Options for Novell IPX Application

The Table 7-2 describes the IPX protocol-dependent parameters of the Remote Node Setup.

Chapter 7 Novell IPX Configuration for LAN-to-LAN 7-7