ZyXEL Communications Prestige 128MH PSTN Router/Hub, 6. Menu 12.2 - Edit IPX Static Route

Prestige 128MH PSTN Router/Hub

Menu 12.2 - Edit IPX Static Route

Route #= 11

Server Name= ?

Active= Yes

Network #= ?

Node #= 000000000001

Socket #= 0451

Type #= 0004

Hop Count= 2

Tick Count= 3

Gateway Node= 1

Press ENTER to CONFIRM or ESC to CANCEL:

Figure 7-6. Menu 12.2 - Edit IPX Static Route

Table 7-3 contains the instructions on how to configure the Edit IP Static Route Menu.

Table 7-3. Edit IPX Static Route Menu Fields

Field	Description
Server Name	In this field, enter in the name that has been configured for the server. This name must
	be the exact name configured in the NetWare server.
Network #	This field contains the internal network number of the remote server that you wish to
	access. Do not use [00000000] or [FFFFFFFF] for this field.
Node #	This field contains the address of the node on which the server resides. If you are using a
	Novell IPX implementation, this value is [000000000001].
Socket #	This field contains the socket number on which the server will receive service requests.
	The default for this field is hex [0451].
Type #	This field identifies the type of service the server provides. The default for this field is hex
	[0004].
Gateway Node	In this field, enter the number (1-4) of the Remote Node that is linked to this static route.
	That is, the Remote Node that you wish to route the packet to.
Hop Count and	These two fields have the same meaning as those in the Remote Node Setup.
Tick Count

Once you have completed filling in the menu, press [Enter] at the message [Press Enter to Confirm] to save your selections, or press [Esc] to cancel to cancel your selections.

7-10Chapter 7 Novell IPX Configuration for LAN-to-LAN