6
3
Setup and Adjustment
1. Remove any packing material which may be between
upper and lower handles.
a. Pull up and back on u pper handle as shown in
Step 1. Make certain the lower handle is seated
securely into the handle mounting brackets.
b. Tighten hand kn obs securing upper handle to
lower handle. Make sure that each carriage bolt is
seated properly in the handle.
2. Locate hairpin clip in one hole on the weld pin on eac h
side of lower handle.
a. Remove hairpin clip fr om this hole. Using a pair of
pliers, insert hairpin clip into the other hole on the
weld pin. Repeat on other side.
b. Insert a c arriage bolt from the hardware pack into
the upper hole on the handle mounting bracket.
Secure with one plastic wing nut, also included
in the hardware pack. Repeat on other side with
remaining items from hardware pack.
3. The rope guide is attached to the right s ide of the
upper handle. Loosen the wing nut which secures the
rope guide.
a. Hold the bl ade control against upper handle.
b. Pull starter ro pe out of the engine. Release the
blade control.
c. Slip starter rope into rope guide. Tighten wing nut.
4. Insert post on cable ties into holes provid ed on the
lower handle. Pull cable tie tight and trim excess.
Step 3
Step 2
NOTE: Stand behind
the mower as if you
were going to operate
it. Your right hand cor-
responds to the right
side of the mower; your
left hand corresponds
to the left side of the
mower.
Step 1
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Fill
up gasoline and oil
as instructed in the
accompanying engine
manual BEFORE
operating your mower.
Step 4
IMPORTANT
DO NOT crimp the
cables when lifting the
handle up.