ASSEMBLY INSTRUCTIONS

INSTALLING THE SHOULDER HARNESS (Optional)

WARNING: To avoid serious personal injury,

never attempt to start the unit when standing with the unit clipped to the shoulder strap. Always follow the starting procedures as described in the Starting/ Stopping Instructions section.

The shoulder strap is an optional accessory.

1.Push the strap through the center of the buckle.

2.Pull the strap over the cross bar and down through the slot in the buckle (Fig. 7).

Clip

Fig. 7

3.Snap the clip on to the support fittings on the front or back of the handle. Clip to the front portion of the handle when using the unit as a blower, and clip to the back portion of the handle when using the unit as a vacuum (Fig. 8).

Attach Here for

Blowing

Attach Here for

Vacuuming

Fig. 8

4.While standing in the operating position, adjust the length to fit the operator’s size. Pull the tab to lengthen, pull the strap to shorten (Fig 9).

Fig. 9

10