| KNOW YOUR UNIT |
APPLICATIONS |
|
As a trimmer: | Fuel Cap |
• Cutting grass and light weeds |
|
• Edging | Starter Rope Grip |
• Decorative trimming around trees, fences, etc. |
|
As a brushcutter: |
| Shaft Grip | |
• Cutting weeds and light brush of up to 1/2 inch in diameter | |||
Throttle | |||
Other optional accessories may be used with the YM90BC. Refer | |||
to Operating the | On/Off Stop Control | ||
| |||
Blade Shield / | Shoulder Strap Clip | ||
Shield Mount | |||
|
| ||
Throttle | |||
|
| Control | |
Shaft |
|
| |
Housing |
|
| |
Brush |
| ||
Blade |
|
| |
Gear Housing |
|
| |
Cutting Attachment |
| ||
Shield |
| ||
|
| Engine Stand | |
|
| Line Cutting | |
Cutting Attachment |
| Blade | |
| Spark Plug |
Blue Choke
Lever
Air Filter/
Muffler
Cover
Muffler
Primer Bulb
ASSEMBLY INSTRUCTIONS
On some units, the
INSTALL AND ADJUST THE
1.Place the
(4)Screws
Top Clamp | |
Middle Clamp |
|
Bottom Clamp | Nuts |
| |
| Fig. 1 |
2.While holding the three pieces together, install the four (4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up only when assembled correctly.
3.Place the clamps and the
4.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.
5.Slide the
6.While holding the unit in the operating position (Fig. 3), position the
7.Tighten the clamp screws evenly, until the
Decal
Fig. 2
Fig. 3
4