ASSEMBLY INSTRUCTIONS
OPERATING THE
The
*Do NOT use this attachment with an electric powered product.
WARNING: When using any attachment, read and understand that attachment’s specific manual before you begin operation. Follow all applicable safety information.
Removing the Cutting Attachment or
1.Turn the knob counterclockwise to loosen (Fig. 16).
2.Press and hold the release button (Fig. 16).
3.While firmly holding the upper shaft housing, pull the cutting attachment or
WARNING: To avoid serious personal injury and damage to the unit, shut the unit off before removing or installing
Installing the Cutting Attachment or
NOTE: Place the unit on the ground or on a work bench to make
1.Turn knob counterclockwise to loosen (Fig. 16).
CAUTION:
For edging (when using | 90˚ Edging Hole | |
the line head cutting | ||
(Trimmer Only) | ||
attachment with EZ- |
| |
Link™ models), lock the |
| |
release button of the |
| |
cutting attachment into |
| |
the 90° edging hole |
| |
(Fig. 18). |
|
Knob
Fig. 18
Release Button | |
|
Knob
Guide Recess
Fig. 16
2.While firmly holding the
NOTE: Aligning the release button with the guide recess will help installation (Fig. 16).
Primary Hole | Release Button | |
|
|
Upper Shaft Housing
Lower Shaft Housing
Fig. 17
3.Turn the knob clockwise to tighten (Fig. 18).
CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit.
7