Multi-Link Stick manual Audible Read Back of PROGRAMMING-BEEP Beep BEEP-BOOOOOOOP

The Stick Response: Answers with the “OK” tone twice. The LED returns to normal blinking which demonstrates that your touch tone phone connected to the “VOICE 1" port is off-hook.

Check and see if your mom is on the other end of the line. If not, hang up the phone.

NOTE: If The Stick does not receive a command within 30 seconds, it will give y o u an “OK” tone and exit the programming mode without saving any programming. Basically it is acting as if you have dialed "90" (See section titled

Programming Commands.)

3.3 AUDIBLE “READ BACK” OF PROGRAMMING-BEEP

BEEP BEEP-BOOOOOOOP!

There is a programming command that allows The Stick to audibly “read back” (via the phone) the values of any program register. This feature is handy when you forget what you have just programmed and want a quick read back or checking to see if a feature is (de)activated before leaving your home or office.

There are two types of tones that The Stick will transmit through your receiver on the audible “read -back”:

*A clipped, high pitched “bip” which has a numerical value of one. *A long, low pitched “beep” which has the numerical value of five.

The chart below describes the audible tones which coincide with each number or symbol in a register.

NUMBER/SYMBOL		I	AUDIBLE TONES
1		I	"BIP"
2		I	"BIP BIP”
3			“BIP BIP BIP”
4			“BIP BIP BIP BIP”
5			“BEEP”
6		I	“BEEP BIP”
7		I	“BEEP BIP BIP”
8			“BEEP BIP B I P BIP”
9			“BEEP BIP BIP BIP BIP”
0	I		“BEEP BEEP”
*	I		“BEEP BEEP BIP"
#	I		“BEEP BEEP BIP BIP”

1 2