Multiquip CD613H18 (Honda GX390 Gasoline Engine) Stow Cutter 1 SAW PREPARATION/PRE-INSPECTION

STOW CUTTER 1 SAW — PREPARATION/PRE-INSPECTION

V-belt Alignment and Tensioning

This saw is equipped with a premiumV-belt that has been aligned and tensioned by factory personnel. The V-belt must be aligned and tensioned for proper operation of the saw.

Use the following procedure to check the alignment of V-belt:

1.Remove the bolts that secure the V-belt cover (Figure 9) to the saw frame.

Figure 9. V-Belt Cover

2.Check uniform parallelism (Figure 10) of V-belt and pulley (sheaves). Use a straight-edge or machinist's square against both pulleys and adjust both pulleys until equally aligned.

Figure 10. Pulley Alignment

3.Check V-belt tension by using a tension meter (3.0 lbs.) against the inside belt at a mid point between the two pulleys, or by deflecting the center belt at a mid point 3/16" (5 mm).

4.DO NOT over or under tighten the V-belt. Severe damage can occur to the saw and engine crankshaft if the belt is over-tensioned. A decrease of power to the blade and poor performance will result if the belt is under-tensioned (loose on pulleys).

V-belt alignment must be

NOTE rechecked after adjusting belt tension.

STOW CUTTER 1 SAW — OPERATION & PARTS MANUAL — REV. #6 (06/06/08) — PAGE 17