Multiquip CD605E16 (5 HP Electric Motor) STOW CUTTER 1 SAW - INITIAL START-UP, Initial Start-Up

	STOW CUTTER 1 SAW — INITIAL START-UP
INITIAL START-UP	3. Place the Engine ON/OFF switch (Figure 13) in the "ON"
	position.

CAUTION

DO NOT attempt to operate the saw until the Safety, General Information and Inspection sections of this manual have been read and thoroughly understood. Depending on engine manufacturer, operating steps may vary. See engine manufactures operating manual.

CAUTION

NEVER operate the saw in a confined area or enclosed area structure that does not provide ample free flow of air.

ALWAYS wear approved eye and hearing protection before operating the saw.

NEVER place hands or feet inside the belt guard or blade guard while the engine is running. ALWAYS shut the engine down before performing any kind of maintenance service on the saw.

Figure 13. Engine ON/OFF Switch

The CLOSED position of the choke lever enriches the fuel mixture for starting a COLD engine.

NOTE The OPEN position provides the correct fuel mixture for normal operation after starting, and for restarting a warm engine.

4.Place the Choke Lever (Figure 14) in the "CLOSED " position.

1.Ensure the diamond blade has been mounted correctly and that it is raised above the surface you are about to saw.

2.Place the fuel valve lever (Figure 12) to the "ON" position.

Figure 14. Choke Lever

CAUTION

The engine speed has been set at the factory. Changing the governor speed could damage the blade and/or the saw.

Figure 12. Engine Fuel Valve Lever

PAGE 20 — STOW CUTTER 1 SAW — OPERATION & PARTS MANUAL — REV. #6 (06/06/08)