Multiquip CX100HFE, CX300HF, CX400HFE, CX600HFE manual CX-HF Series Hand Mixers Setup, Assembly

CX-HF SERIES HAND MIXERS — SETUP

Assembly

Before using the hand mixer, the following steps need to be performed.

1.Insert the mixing tools (see Table 3 for the different mixing tools/paddles available) into the HEXAFIX® coupling as far as necessary to lock the tools in place, automatically (see Figure 2).

PULL BACK

INSERT

2.A 120V/230V power supply can also be used. Make sure that the power supply conforms to the specifications on the nameplate of the mixer. Voltage decrease of more than 10% will cause loss of power and overheating.

3.Use an extension cord (seeTable 2) of adequate current carrying capacity. NEVER use a worn or frayed exten- sion cord. Insert the electric motor's power plug into one end of the extension cord.

DANGER

NEVER touch the power cord (Figure 3) with wet hands or while standing in water when it is connected to a power source. The possibility exists of electrical shock (electrocution) even death. NEVER spray water directly on the electric motor.

Figure 2. Inserting Mixing Tools

Electric Connections

CAUTION

DO NOT attempt to operate the mixer until the Safety, General Information and Set-Up sections have been read and understood.

CAUTION

Before plugging the power cable, check and make sure that the ON/OFF switch operates properly and returns to the OFF position when released.

1.Connect the hand mixer power cable to a 110V or 230V, 50/60 Hz power source, depending on the unit you have. Make sure you conform to the specifications on the nameplate of the mixer.

Figure 3. Extension Cord (Wet Hands)

To prevent personnel from tripping over the extension cord, position the

NOTE extension cord so that it lays flat and is not curled.

CX-HF SERIES MIXERS — OPERATION AND PARTS MANUAL — REV. #3 (03/11/08) — PAGE 13