Multiquip DCA125USJ DCA-125USJ - GENERATOR SHUT-DOWN PROCEDURE, Normal Shutdown Procedure

DCA-125USJ — GENERATOR SHUT-DOWN PROCEDURE

WARNING - SHUTTING DOWNTHE GENERATOR

NEVER stop the engine suddenly except in an emergency.

Normal Shutdown Procedure

To shutdown the generator use the following procedure:

1.Place both the MAIN, GFCI and LOAD circuit breakers as shown in Figure 38 to the OFF position.

3.Let the engine cool by running it at low speed for 3-5 minutes with no load applied.

4.Place the MPEC Control Switch (Figure 55) to the OFF/RESET position.

Emergency Shutdown Procedure

1.To shut-down the engine in the event of an emergency, switch the MAIN, GFCI and LOAD (Figure 38) circuit breakers to OFF position.

2.Place the MPEC Control Switch switch (Figure 55) to the OFF/RESET position.

Figure 55. MPEC Control Switch (Off/Reset)

5.Verify that the all status LED’s on the MPEC display are OFF (not lit).

6.Remove all loads from the generator.

7.Inspect entire generator for any damage or loosening of components that may have occured during operation.

DCA-125USJ — OPERATION AND PARTS MANUAL — REV. #2 (01/27/11) — PAGE 39