Multiquip dca45ssiu4 manual Generator OUTPUTS/gauge reading, How to Read the Output Terminal Gauge

GENERATOR OUTPUTS/gauge reading

How to Read the Output Terminal Gauge

The AC ammeter and AC voltmeter change-over switches on the control panel DO NOT effect the generator output. They are provided to help observe how much power is being supplied, produced at the UVWO terminals lugs.

Before taking a reading from either gauge, set the Voltage Selector Switch (Figure 14) to the position which produces the required voltage (For example, for 3Ø 240V, choose the center 3Ø 240/139V position on the voltage selector switch.)

Figure 14. Voltage Selector Switch

240/139V 3Ø Positio

NOTICE

For 3Ø 208V/1Ø,120V, place the Voltage Selector Switch in the 3 Phase 240/139 position.

Reading Voltage

To determine the voltage between two terminal lugs, set the AC Voltmeter Change-Over Switch to the appropriate setting (Figure 15) to activate the AC Voltmeter Gauge (Figure 16) and read the available voltage between the two lugs.

For example, to measure the voltage between the W and U terminal lugs, set the AC Voltmeter Change-Over Switch to W-U and read the AC Voltmeter Gauge.

Reading Amperage

To determine the amperage at a terminal lug, set the AC Ammeter Change-Over Switch to the appropriate setting (Figure 17) to activate the AC Ammeter Gauge (Figure 18) and read the available amperage at the terminal lug.

For example, to measure the amperage at the U terminal lug, set the AC Ammeter Change-Over Switch to U and read the AC Ammeter Gauge.

Figure 17. AC Ammeter	Figure 18. AC Ammeter
Change-Over Switch	(Amp Reading on U Lug)

NOTICE

The ammeter gauge will only show a reading when the Output Terminal Lugs are connected to a load and in use.

Figure 15. AC Voltmeter	Figure 16. AC Voltmeter
Change-Over Switch	Gauge

DCA45SSIU4 60 hz Generator • operation and parts manual — rev. #1 (10/24/13) — page 27