Multiquip manual EM-900SDCEMIXER — CONTROLS AND COMPONENTS, Mixer Major Components

EM-900SDCE MIXER — CONTROLS AND COMPONENTS

1.Engine Cover — Lift this cover to gain access to the engine compartment.

2.Clutch Engagement Lever — Push the clutch lever forward, toward the tow end of the mixer to engage clutch. Once the clutch is engaged the paddle shaft will begin to rotate. To disengage clutch pull the clutch backwards towards the engine.

3.Throttle Control/Stop Switch — Pull all the way out to achieved maximum engine RPM's.To stop the engine, push the RED stop button inwards.

4.Safety Grill — Provided for operator safety.This safety grill is designed to keep hands and solid objects out of the mixing drum when in use.This grill should be closed at all times when mixer is in use. DO NOT remove the grill or grill opening bar. Keep the grill clean by washing it down daily.

5.Bag Cutter— This feature allows compound mixing bags to be opened easily, therefore allowing the contents of the bag to fall directly into the mixing drum.

6.Dump Handle — Pull this handle downward to dump the contents of the drum. Push the handle upward to return the drum to its vertical position.

7.Transport Handle — Use this T-handle to transport the mixer. NEVER tow this mixer on a highway.

8.Pivot Point/Zerk Fitting — There is, on each end of the mixing drum a zerk grease fitting. These fittings lubricate the dumping mechanism. Lubricate both fittings at least twice a week.

9.Dump Handle Release Pin — Pull this pin outward (spring loaded) to release the drum, then pull down on the dump handle to place the drum in the dump position. When drum is in dump position, pin will automatically lock drum.

10.Tires — This unit employes the use of soild rubber tires.

11.Transport Bar Release Latch — To transport the mixer un-hook the transport bar from the latch. When work is being performed ALWAYS have the transport bar latched in the upright position.

12.Safety Grill Lock Handle — To prevent injury to hands and arms, the safety grill should ALWAYS be locked when the mixing of plaster or mortar is required. Also when transporting the mixer the safety grill should be locked.The safety grill should only be un-locked when cleaning of the blades and drum is required.

13.Steel Mixing Drum — Mixing materials such as concrete, mortar, plaster are to be placed into this drum for mixing. Always clean the drum after each use.

14.Mixing Paddles — Used in the mixing of material. This unit uses four different types of paddles to provide a fast uniform mix.

15.Bunjee Latch — Use this latch to secure the engine compartment cabinet.

16.Fork Lift Pocket — When lifting of the mixer is required, use these fork lift pockets to lift the mixer. Remember to insert the forks of the fork lift a minimum of 60.96 cm. (24 inches) into the mixer's fork lift pocket.

Figure 2. Mixer Major Components

PAGE 14 — MULTIQUIP EM-900SDCE — OPERATION AND PARTS MANUAL — REV. #2 (09/14/07)