EM-900SDCE MIXER —TOUBLESHOOTING (ENGINE/MIXER)
TABLE 5. ENGINE TROUBLESHOOTING (CONTINUED)
SYMPTON | POSSIBLE PROBLEM | SOLUTION | |
|
|
| |
| Fuel tank empty? | Replace fuel filter. | |
|
|
| |
| Fuel filter clogged? | Replace fuel filter. | |
|
|
| |
Low engine power, output and | Fuel tank venting is inadequate? | Ensure that tank is adequately vented. | |
speed. |
|
| |
Speed control lever does not remain in selected | See engine manual for corrective action. | ||
| |||
| position? |
| |
|
|
| |
| Engine oil level too full? | Correct engine oil level? | |
|
|
| |
Low engine power output and | Air filter blocked? | Clean or replace air filter. | |
|
| ||
Incorrect valve clearances? | Adjust valves per engine specification. | ||
low speed, black exhaust | |||
smoke. |
|
| |
Malfunction at injector? | See engine manual. | ||
| |||
|
|
|
Practically all breakdowns can be prevented by proper handling and maintenance inspections, but in the event of a breakdown, please take a remedial action following the diagnosis based on the Mixer Troubleshooting (Table 6) information shown below. If the problem cannot be remedied, please leave the unit just as it is and consult our company's business office or service plant.
TABLE 6. MIXER TROUBLESHOOTING
SYMPTOM | POSSIBLE PROBLEM | SOLUTION | |
|
|
| |
| Broken connector pin? | Replace connector pin. Use P/N 963157 when ordering. | |
|
| ||
Blades will not rotate. |
|
| |
| Defective or | Adjust or replace clutch. | |
|
|
| |
Material leaking from drum | Worn or defective paddle shaft | Adjust or replace seals. | |
ends. | seals? | ||
| |||
|
|
| |
| Malfunction in | Clean or replace air filter. | |
| air filter clogged? | ||
|
| ||
|
|
| |
Drum difficult to discharge (tilt) | Defective or worn drum support | Apply grease to bracket or replace. | |
| brackets? |
| |
|
|
| |
| Blades adjusted too tight. | Adjust blades until they almost touch side walls of drum. | |
|
|
|
PAGE 22 — MULTIQUIP