Multiquip operation manual FS 1 Concrete SAW Basic Engine Components

Models: FS 1

1 56
Download 56 pages 21.01 Kb
Page 16
Image 16

FS 1 CONCRETE SAW — BASIC ENGINE COMPONENTS

Figure 5. Engine Controls and Components

INITIAL SERVICING

5.

FuelValve Lever – OPEN to let fuel flow, CLOSE to stop

The engine (Figure 5) must be checked for proper lubrication and

 

the flow of fuel.

6.

Choke Lever – Used in the starting of a cold engine, or in

filled with fuel prior to operation. Refer to the manufacturers Engine

manual for instructions & details of operation and servicing.

 

cold weather conditions. The choke enriches the fuel

 

 

mixture.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

WARNING

Adding fuel to the tank should be accomplished only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill,

DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3.

Engine ON/OFF Switch – ON position permits engine

 

starting, OFF position stops engine operations.

4.

Recoil Starter (pull rope) – Manual-starting method. Pull

 

the starter grip until resistance is felt, then pull briskly and

 

smoothly.

7. Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter cannister to gain access to filter element.

Operating the engine without

an air filter, with a damaged air

NOTEfilter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

8. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.

9. Muffler – Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER

operate the engine with the muffler removed.

10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.

PAGE 16 — MQ-WHITEMAN FS1 CONCRETE SAW — PARTS & OPERATION MANUAL — REV. #3 (04/24/03)

Page 16
Image 16
Multiquip operation manual FS 1 Concrete SAW Basic Engine Components