gb2000 balloon lighT• operaTion and parTs manual — rev. #3 (08/30/12)— page 19
type 2 COMpOnents (s/n G1900119 and abOve)Figure 4. GB2000 Components
(Type 2 S/N G190019 And Above)
5
3
2
1
4
6
7
8
1. lamp Fixture — Made of heat resistant polyester
balloon, with a diameter of 35.5 inches (902 mm) and
two 1000 watt metal halide lamps.
2. locking pin — Locks the lamp fixture in place when
attached to the pole on the bracket.
3. balloon power Cable — Provides AC power to the
lamps, fan and baloon inflation circuit.
4. adapter plate — Attaches to the T-Bar and mast
interface of the light tower to allow the GB2000 to be
installed.
5. Junction box — Holds the electrical connection and
cables to connect the lamp fixture to the T-Bar and to
the power cable.
6. support bracket — Attache s to T-Bar to support
adapter plate (hardware not shown).
7. Connector Caps — Pr ovides pr otecti on to the
receptacles on the junction box when not in use.
8. Fan power Cable — 38 ft. (11.5 meters) cable that
provides 120 VAC from a GFCI receptacle (generator)
to the T-Bar mounted junction box to run the balloon
fan and inflate the balloon.
NOTICE
Type 2 adapter plate fits most conventional light tower
masts.