page 36 —gb2000 balloon lighT• operaTion and parTs manual — rev. #3 (08/30/12)
MaintenanCe
replaCing lamp\
1. Unzip the zipper at the bottom of the balloon and roll
the balloon up to expose the lamp. See Figure 33.
Figure 33. Exposing Balloon
2. Release the lamp guard hooks from the poles and
remove the two lamp guards. See Figure 34.
Figure 34. Removing Lamp Guard
danger
Never attempt to re place lamp in a wet place. The
possibility exists of electric shock.
Warning
Always allow sufficient time for the lamp to
cool down before replacing. The possibility
exists of sev ere burns if ho t l amp is
touched.
CauTion
Always shutdown power source and remove balloon
assembly from mast when replacing a broken lamp.
Utmost care should be taken in handling broken lamp.
The possibility exists of serious injury from handling a
broken lamp.
BALLOON
ZIPPER
LAMPGUARD
LOCKHOOK
3. Press the tabs on the lamp holder and push up lamp
holder to release it from lamp. Do the same to the lower
lamp if necessary. See Figure 35.
Figure 35. Lamp Holder
4. Remove lamp from the lamp socket by turning lamp
counterclockwise. See Figure 36.
Figure 36. Removing Lamp
5. Install new lamp into socket and turn lamp in a
clockwise direction until tight. See Figure 37.
Figure 37. Installing New Lamp
LAMPHOLDER
LAMP
HOLDER
STOPPER
LAMP
LAMP
SOCKET
LAMP
LAMP
SOCKET