Multiquip HPHA46411H Insert the cable end through the yoke eyelet Figure, Slack from the cable

HPLA/HPHA-SERIES 46"TROWEL — ASSEMBLY AND INSTALLATION

		Pre-load Adjustment (Quick-Pitch™ Models Only)
2.	Lock the spring in the compressed position, by releasing	1.	After the Quick-Pitch™ handle has been installed on the
	the blade pitch adjustment trigger, (Quick-Pitch™ model).		trowel, spring pre-load adjustment will be required.
3.	Remove one brass set nut from the blade pitch cable end	2.	Locate the adjustment screw on the underside of the handle
	as shown in (Figure 13).		tube (Figure 15).

4.Thread the second brass set nut towards the cable as far as possible.

Figure 13. Blade Pitch Cable

5.Insert the cable end through the yoke eyelet (Figure 14)

	Tighten the first brass set nut by hand to remove all the		Figure 15. Pre-load Adjustment
	slack from the cable.
6	Using a wrench, tighten the second brass set nut up against	3.	A decal has been placed on the side of the handle tube to
	the yoke boss.This will lock the cable in place.		assist the user in the adjustment of the spring.
7.	Use a wrench and finish tightening the first brass set nut up	4.	Align the arrow on the adjustment screw with the letter "B"
	against the yoke boss.		COMBO on the decal.
		5.	Test the pitch control operation and adjust if necessary.

YOKE
THREAD CABLE END
THROUGH YOKE EYELET
TIGHTEN SECOND
BRASS SET NUT	USE A WRENCH TO
AGAINST YOKE BOSS	TIGHTEN FIRST BRASS
	SET NUT AGAINST YOKE BOSS

Figure 14. CableYoke Attachment

HPLA/HPHA-SERIES 46" WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (07/06/10) — PAGE 21