Multiquip HPLA46411H HPLA/HPHA-SERIES 46TROWEL Operation, Pitchingthe Blades, Quick Pitch Handle

HPLA/HPHA-SERIES 46"TROWEL — OPERATION

The following steps are intended as a basic guide to machine operation, and are not to be considered a complete guide to concrete finishing. We suggest that all operators (experienced and novice) read “Slabs on Grade” published by the American Concrete Institute, Detroit, Michigan. Read the “Training” section of this manual for more information.

PITCHINGTHE BLADES

Quick Pitch Handle

1.To pitch the blades upwards using the "Quick-Pitch™"T-handle, (Figure 28) simply squeeze the trigger lock and pull the T-handletowards the operator. Pushing theT-handletowards the engine will cause the blades to lay flat.

Figure 28. Quick-Pitch™ T- Handle

Standard Handle

1.To pitch the blades upwards using the "Standard" handle, (Figure29)simplyturnthestar-wheelclockwise.Turningthe starwheelcounterclockwise willcausethebladestolayflat.

Maneuvering the Trowel

1.Get into the operator’s position behind the handle. With a secure foothold and a firm grasp on the handles slowly increase the engine speed until the desired blade speed is obtained.

2.Tomaneuverthetrowel,gentlyliftuponorpressdownonthe main trowel handle.To move the machine to the operator’s left,liftuponthehandle,tomovemachinetotheright,push down on the handle.

3.The best method for finishing concrete is to slowly walk backwards (Figure 30) with the trowel, guiding the trowel fromsidetoside.Thiswillcoverallfootprintsonwetconcrete.

4.Remember that if you let go of the trowel, just step away and letthetrowelcometoacompletestopbeforetryingtorecover thetrowel. See(Figure26)toseetheareaaroundthetrowel to keep clear of.

Figure 29. Standard Handle

PAGE 26 — HPLA/HPHA-SERIES 46" WALK-BEHINDTROWEL— OPERATION AND PARTS MANUAL — REV. #6 (07/06/10)