HS81A CUT-OFF SAW —WATER KIT INSTALLATION INSTRUCTIONS
Figure 9. Water Kit Parts
Figure 10. Water Kit Assembly Points
Contents of Water Kit
The contents of the Water Kit cannot be purchased seperately. See Water Kit Assembly in Parts Section of this manual for Water Kit part number.
Hose Clamp
Socket Head Cap Screw w/ Washer
Quick Disconnect Fitting
Water Hose
Hex KeyTool (Included withTool Kit)
Plastic Ties
Wet Air Filter Canister (Sold Seperately)
Water Kit Installation Procedure
Connect the Quick Disconnect Fitting to the single end of the Water Hose .
Snap fit the Water Hose Outlets to the Holes in the Blade Guard .Orient the Water Hose through the
Front Handle.
Loop the Hose Clamp around theWater Hose and fasten the clamp to the Roller Bar Support Arm
using the Socket Head Cap Screw w/ Washer , and Hex KeyTool .
Use the PlasticTies as preferred to further secure the hose fittings and water hose to the saw.
When using the Water Kit option for your saw, the Dry Air Filter Canister MUST be replaced with the Wet Air Filter Canister (See Air Filter Kit Assembly in Parts Section of this manual).
Figure 11. Wet Air Filter Canister
HS81A
