Multiquip jwn24hscsl SPARE Drive Belt Removal Using Replacement Drive Belt, Spare Belt Removal

maintenance

sPARE Drive Belt REMOVAL (Using Replacement Drive Belt)

The JWN-SERIES Ride-On Power Trowel is equipped with a replacement drive belt (spare) carrier, which is mounted on the inboard side of the left-side gearbox . Make sure that there is ALWAYS a spare drive belt in the drive belt carrier before the trowel is placed on a slab to finish concrete.

In the event of a drive belt failure, the spare (replacement) drive belt can be used for quick replacement at the job site for continued trowel operation.

1.To replace an existing drive belt with the spare drive belt, remove the 2 bolts that secure the spare belt holder to the left-side gearbox adapter plate. (Figure 17) Take care not to contaminate the replacement drive belt with grease or dirt.

REMOVE

SPARE DRIVE 2 PLACES

BELT HOLDER

SPARE

DRIVE BELT

REMOVE

LEFT-SIDE

GEARBOX

ADAPTER PLATE

Figure 17. Spare Belt Removal

2.Remove existing drive belt from clutch and lower drive pulley, by cutting belt.

3.Ensure all remnants of old drive belt have been removed from the sheaves/grooves of the clutch and lower pulley

4.Slide spare drive belt over the CV-joint (Figure 18) an onto the lower drive pulley.

SPARE

DRIVE BELT

LOWER DRIVE

PULLEY

CV-JOINT

Figure 18. Spare Drive Belt Routing

5.Next, squeeze the drive belt (Figure 19) and pull upwards and towards the rear of the trowel. This will spread open the faces of the lower drive pulley.

PULL UPWARDS
AND TOWARDS	DRIVE BELT
REAR OF TROWEL

LOWER

PULLEY

Figure 19. Spare Drive Belt Placement

(Lower Pulley)

page 26 — JWN-SERIES RIDE-ON POWER TROWEL • operation manual — rev. #1 (05/12/12)