maintenance

6.Place spare drive belt onto clutch as shown in Figure 20

CLUTCH

GROOVES

DRIVE

BELT

Figure 20. Spare Drive Belt Placement (Clutch)

7.Reinstall belt guard assembly.

Starting The Trowel/Testing

1.While sitting in the operator’s position, start the trowel as referenced in the Operator’s Manual. Be sure to check the engine oil level prior to starting the engine.

CAUTION

The engine’s exhaust contains harmful emissions.

ALWAYS have adequate ventilation when operating. Direct exhaust away from nearby personnel.

2.Run machine, bringing throttle up so clutch engages. Cycle the engine from idle to full throttle twice, and shut off engine. Remove key.

Spare Drive belt installation CV-joint Assembly Removal (left-side)

1.If necessary, place the trowel on suitable supports (jack-stands) and observe all safety precautions.

2.Starting at the left-side gearbox, use a 1/4" allen wrench and remove the 3 bolts and lock washers that secure the CV-joint (Figure 21) to the left-side gearbox. Retain mounting hardware for later use.

REMOVE 3 PLACES

GAP

LEFT-SIDE

GEARBOX CV-JOINT COUPLER

Figure 21. CV-Joint Removal

3.Once the CV-joint has been separated from the left- side gearbox coupler, push the CV-joint inward so that a gap (Figure 21) exists between the gearbox coupler and CV-joint.

4.Slide new spare drive belt between gearbox coupler and CV-joint.

SPARE DRIVE

INSTALL

BELT HOLDER

2 PLACES

(INSTALL)

 

LEFT-SIDE

GEARBOX

ADAPTER PLATE

COUPLER

CV-JOINT

SPARE

DRIVE BELT

Figure 22. Spare Drive Belt Routing

5.Mount new spare drive belt and cover ( Figure 22) onto left-side gearbox. Reinstall the 2 bolts that secure the spare belt holder to the left-side gearbox adapter plate.

JWN-SERIES RIDE-ON POWER TROWEL • operation manual — rev. #1 (05/12/12) — page 27

Page 27
Image 27
Multiquip jwn24htcsl, jwn24hscsl Starting The Trowel/Testing, Place spare drive belt onto clutch as shown in Figure