Multiquip manual Components, MTR40SF Rammer

components

8

7

1

3

2

9

6

11

5

11

10

4

Figure 1. MTR40SF Rammer

Figure 1 shows the location of the controls and components for the MTR40SF Tamping Rammer. The functions of each control is described below:

1.Throttle Lever — Used to adjust engine speed (rpm). Move lever forward (SLOW) to reduce engine speed, move lever back toward operator (FAST) to increase speed.

2.Fuel Shut-Off Valve — Supplies fuel from the fuel tank to the engine. To begin fuel flow, move the fuel shut-off valve downward.

3.Primary Air Cleaner — Pre-cleans (first stage) dirt and other debris from entering the engine.

4.Foot — Laminated wood with tempered steel plate for superior shock absorption.

5.Grip — When transporting the rammer, carry it by griping the handle.

6.Nameplate — Displays information regarding the rammer.

7.Handle — To operate rammer GRIP handle assembly firmly on both sides.

8.Fuel Tank/Cap — Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

WARNING

Adding fuel to the tank should be accomplished only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the

fuel residue has been completely wiped up, and the area surrounding the engine is dry.

9.Engine Air Cleaner — Prevents dirt (second stage) and other debris from entering the engine.

10.Dust Sleeve — Prevents dust and debris from entering into the spring cylinder.

11.Zerk Fittings — Lubricates main springs and crankcase bearings.

page 12 — MTX40sf RAMMER • operation and parts manual — rev. #0 (11/28/12)