Multiquip MTR40SF manual Operation, Set the engine ON/OFF switch to the on position start

operation

CAUTION

Failure to understand the operation of the Tamping Rammer could result in severe damage to the unit or personal injury.

When starting the MTR40SF, perform the following:

1.Open the fuel shut- off valve by moving the fuel cock lever to the open position (Figure 7).

.

4.In cold weather, start the unit with choke lever "Fully Closed" Figure 10). In warm weather or when the engine is warm, the unit can be started with choke halfway or completely open.

Figure 7. Fuel ShutOff Valve (Open)

2.Set the engine ON/OFF switch (Figure 8) to the "ON" position (start).

Figure 8. ON/OFF Switch (ON Position)

3. Move the throttle lever to the "IDLE" position (Figure 9).

Figure 9. Throttle Lever (Idle)

Figure 9. Throttle Lever (Idle)

Figure 10. Choke Lever (Closed)

5.Grip the recoil starter (Figure 11) handle and pull it until you feel a slight resistance. Then pull sharply and quickly. Return the recoil starter handle to the starter position before releasing.

Figure 11. Recoil Starter

6.If engine fails to start, move the choke lever (Figure 10) to the half open position to avoid flooding.

7.Repeat steps 1 thru 6.

8.If the engine does not start after repeated attempts, check the spark plug for excess fuel. Clean and replace the spark plug as needed.

page 16 — MTX40sf RAMMER • operation and parts manual — rev. #0 (11/28/12)