Multiquip operation manual MVH-304DSB-OPERATION, Recoil Start

Recoil Start

1.Open the fuel cock (Figure 9).

2.Move the throttle lever to the START position by opening it to about 20 degrees (Figure 10).

3.Grasp the starter grip (Figure 12) and slowly pull it out.The resistance becomes the hardest at a certain position, corresponding to the compression point. Pull the starter grip briskly and smoothly for starting.

Figure 12. Engine Start Handle

4.Push down decompression lever (Figure 13) and release.

MVH-304DSB—OPERATION

1.Grasp the compactor's hand grip (Figure 14), and move the engine throttle lever (Figure 14) quickly to the fast position.

2.With the throttle lever in the fast position, the engine speed should be around 2,300 RPM, therefore engaging the cen- trifugal clutch

Figure 14. Throttle Lever (Fast)

ALWAYS move the throttle lever

NOTE quickly without hesitation, because increasing the engine speed slowly causes the clutch to slip.

Figure 13. Decompression Lever

5.If the engine does not start, repeat steps 4 and 5.

TRAVELING

CAUTION :

Make sure to follow all safety rules referenced in thesafetysectionofthismanualbeforeoperating compactor. Keep work area clear of debris and other objects that could cause damage to the compactor or bodily harm.

3.To make the compactor move in the forward direction push the travel lever ( Figure 15) forward.

Figure 15. Direction Lever

PAGE 18 — MQ-MIKASA MVH-304DSB PLATE COMPACTOR — PARTS & OPERATION MANUAL — REV. #2 (11/16/05)