Multiquip manual MVH-406DSY-MAINTENANCE, Bleeder Plug BATTERY MAINTENANCE Option

CAUTION

Make sure hydraulic oil is at a normal safe operating level. DO NOT over fill. Over filling (excessive oil) will cause excess oil to blow out of bleeder plug.

3.Loosen bleeder plug located at top of hydraulic cylinder on side of vibrator (Figure 32). Air remaining in the circuit will be forced out of the bleeder plug. Once all air has been purged from the hydraulic system, tighten bleeder plug securely

4.Re-insert oil plug into hydraulic oil tank and tighten securely. Re-install breather cap.

CAUTION

The bleeder plug should only be loosened, but not removed.

Figure 32. Bleeder Plug

BATTERY MAINTENANCE (Option)

Mishandling of the battery shortens the service life of the battery and adds to maintenance cost. When handling the battery do the following:

CAUTION

Wear safety glasses or face mask, protective clothes, and rubber gloves when working with battery.

zThe battery electrolyte contains sulphuric acid, be careful not to let the battery electrolyte come in contact with your body or clothing.

zAlways check the battery terminals periodically to ensure that they are in good condition.

MVH-406DSY—MAINTENANCE

zAlways wear eye protection and rubber gloves, since the battery contains sulfuric acid which burns skin and eats through clothing. In case of contact, flush thoroughly with water and contact a doctor immediately.

zUse wire brush or sand paper to clean the battery terminals.

zAlways check battery for cracks or any other damage. If white pattern appears inside the battery or paste has accumulated at the bottom, replace the battery.

zIf the compactor will not be in operation for a long period of time, store in cool dry place and check the battery charge level every month to maintain the performance of the battery.

zCheck the battery regularly and make sure that each electrolyte level is to the bottom of the vent well (Figure 33). If necessary add only distilled water in a well- ventilated area.

Figure 33. Battery Electrolyte Levels

BATTERY CHARGING

zDO NOT charge battery with the battery cables connected to the compactor. The diodes will be damage by the high voltage.

zBatteries generate hydrogen gas which can be highly explosive. DO NOT smoke or allow flames or sparks near the battery, especially during charging of the battery.

zCharge the battery in a open air environment (plenty of ventilation).

zBefore charging , remove the cap from each cell of the battery.

zConnect the positive (+) lead of the charger to the positive

(+) terminal of the battery and the negative (-) lead of the charger to the negative (-) terminal of the battery. DO NOT reverse the polarity when charging. Reverse polarity will damage the charger rectifer or the battery.

PAGE 24 — MVH-406DSY PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #1 (08/13/07)