Multiquip ONE-WAY PLATE COMPACTOR manual Inspection, Before Starting

Models: ONE-WAY PLATE COMPACTOR

1 72
Download 72 pages 53.17 Kb
Page 15
Image 15

INSPECTION

Before Starting

1.Read safety instructions at the beginning of manual.

2.Cleanthecompactor,removingdirtanddust.Particularly,the bottom of the plate, engine cooling air inlet, carburetor and air cleaner.

3.Check theair filterfor dirtand dust.If theair filterisdirty,blow through the air filter cartridge from the inside, moving a jet of dry compressed air up and down until all dust is removed. Otherwise replace air filter with a new one.

4.Check carburetor for external dirt and dust. Clean with dry compressedair.

5.Check fastening nuts and bolts for tightness. Loosened screws or bolts due to vibration, could lead to unexpected accident.

Engine Oil Check

1.To check the engine oil level, place the plate compactor on secure level ground with the engine stopped.

2.Remove the filler cap/dipstick from the engine oil filler hole (Figure 3) and wipe it clean.

NOTICE

The Oil Alert system will automatically stop the engine before the engine falls below safe limits. Always be sure to check the engine oil level prior to starting the engine.

Table 3. Oil Type

Season

Temperature

Oil Type

 

 

 

Summer

25°C or Higher

SAE 10W-30

 

 

 

Spring/Fall

25°C~10°C

SAE 10W-30/20

 

 

 

Winter

0°C or Lower

SAE 10W-10

 

 

 

Gasoline Check

1.Remove the gasoline cap located on top of fuel tank.

2.Visuallyinspecttoseeiffuellevelislow. Iffuelislow,replenish with unleaded fuel.

3.When refueling, be sure to use a strainer for filtration. DO NOT top-off fuel. Wipe up any spilled fuel.

Vibrator Oil Check

1.Place the MVC77 Series plate compactor horizontally on a flatsurface.Makesurethecompactorislevelwhenchecking the oil in the vibrator assembly.

2.Check vibratoroillevelbyremoving theplug (vibrator oilgauge) as shown in Figure 5. The oil level should be up to the oil plug. Thevibratorholds 140cc(approximately1pint).IMPORTANT, if oil is required, replace using only SAE 10W-30 motor oil.

Figure 3. Engine Oil Dipstick

3.Insertandremovethedipstickwithoutscrewingitintothefiller neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 4), fill to the edge of the oil filler hole with the recommended oil type (Table 3).Maximum oil capacity is 400 cc.

UPPER LIMIT

Figure 5.Vibrator Oil Plug

LOWER LIMIT

Figure 4. Engine Oil Dipstick

MVC77 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #4 (1/14/11) — PAGE 15

Page 15
Image 15
Multiquip ONE-WAY PLATE COMPACTOR manual Inspection, Before Starting