QP-3TH Pump
Starting Instructions
The following instructions are intended to assist the user in starting the
Before Starting
Place pump as near to water as possible, on a firm flat, level surface.
To prime pump, remove fill cap and fill pump casing with water.If the pump casing is not filled with water before starting, it will not begin pumping.
WARNING
DO NOT open fill cap if pump is hot! Water inside may be under pressure.
Check for leaks between pump and engine.
Check that all hoses are securely attached to the pump.
Check that the discharge hose is not restricted.
Make sure the suction strainer is clean and securely attached to the water end of the suction hose.
CAUTION
NEVER! operate the pump without water in the casing as this will cause damage to the mechanical seal.
The strainer should be positioned so it will remain completely under water. Running the pump with the strainer above water for long periods can damage the pump.
DANGER
DO NOT pump flammable fluids, corrosive chemicals or fluids containing toxic substances. These fluids can create potentially dangerous health and environmental hazards. Contact local authorities for assistance.
Starting the Engine
1.Place the engine fuel valve lever (Figure 1) to the "ON" position.
2.Move the throttle lever (Figure 2) away from the slow position, about 1/3 of the way toward the fast position.
Figure 2. Throttle Lever (1/3 Start Position)
3.Place the choke lever (Figure 3) in the "OPEN " position if starting a cold engine.
Figure 3. Engine Choke Lever (Open)
4.Place the choke lever (Figure 4) in the "CLOSED " position if starting a warm engine or the temperature is warm.
Figure 4. Engine Choke Lever (Closed)
5.Place the engine ON/OFF switch (Figure 5) in the "ON " position.
Figure 1. Engine Fuel Valve Lever (ON Position) | Figure 5. Engine ON/OFF Switch (ON Position) |
|
