QP40TH — SAFETY MESSAGE ALERT SYMBOLS
FORYOUR SAFETY AND THE SAFETY OF OTHERS!
Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the Safety Messages and Operating Instructions could result in injury to yourself and others.
| This Owner's Manual has been | |||
| developed to provide complete | |||
| instructions for the safe and efficient | |||
| operation of the Multiqui pModel | |||
NOTE | QP40TH Centrifugal Trash Pump. | |||
| Refer to the engine manufacturers | |||
| instructions for data relative to its | |||
| safe operation. |
|
| |
| Before | using | these pumps, | |
| ensure | that | the | operating |
| individual has | read and | ||
| understands all instructions in | |||
| this manual. |
|
| |
SAFETY MESSAGE ALERT SYMBOLS
The three (3) Safety Messages shown below will inform you about potential hazards that could injure you or others. The Safety Messages specifically address the level of exposure to the operator, and are preceded by one of three words: DANGER, WARNING, or CAUTION.
DANGER: You WILL be KILLED orSERIOUSLY injured if you do not follow directions.
WARNING: You CAN be KILLED orSERIOUSLY injured if you do not follow directions.
CAUTION: You CAN be injured if you do not follow directions.
Potential hazards associated with the
HAZARD SYMBOLS
Lethal Exhaust Gases
Engine exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled. NEVER operate this equipment in a confined area or enclosed structure that does not provide ample free flow air.
Explosive Fuel
GASOLINE is extremely flammable, and its vapors can cause an explosion if ignited. DO NOT start the engine near spilled fuel or combustible fluids. DO NOT fill the fuel tank while the engine is running or hot. DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system. Store fuel in approved containers, in
Burn Hazards
Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operations. Never operate the engine with heat shields or heat guards removed.
Rotating Parts
NEVER operate equipment with covers, or guards removed. Keep fingers, hands, hair and clothing away from all moving parts to prevent injury.
PAGE 6
