ASSEMBLY INSTRUCTIONS/OPERATIONS

FIGURE 26

5)Using a hammer, strike the wider side of the mounting wedge with controlled, direct blows to firmly seat the multi-accessory attachment into the aluminum disc. Usually one or two direct blows will be sufficient to properly retain the attachment.

CAUTION

Do not apply excessive impact force to the mounting wedge to cause splitting. Once the multi-accessory attachment is seated in the aluminum disc, further impact force on the wedge will not increase the seating force.

FIGURE 27

DANGER

DO NOT OPERATETHE SURFACE GRINDERWITHTHE 229019-017 MOUNTING WEDGES IN AN IMPROPER MOUNTING CONFIGURATION. MOUNTING AWEDGE BETWEEN THE MULTI-ACCESSORY ATTACHMENT ANDTHE OUTSIDE RIB OFTHE ALUMINUM DISC CAN ALLOWTHE WEDGETO COME IN DIRECT CONTACT WITH AVERTICALWALL AND/OR FLOOR OBSTRUC- TION. SUCH OCCURRENCE CAN RESULT IN LOSS OF MACHINE CONTROL, PROPERTY DAMAGE AND/ OR PERSONAL INJURY.

BEFORE OPERATINGTHE SURFACE GRINDERWITH ANY MULTI-ACCESSORY ATTACHMENT, DETERMINE THAT NO PORTION OF THE ATTACHMENT AND/OR MOUNTINGWEDGE EXTENDS BEYONDTHE NORMAL PERIMETER OFTHE ALUMINUM DISC.

CAUTION

Improper seating force created by an excessive blow to the mounting wedge will not allow the attachment to properly release from the aluminum disc if direct contact with a foreign object is made. Such occurrence can result in property damage and/or personal injury. The correct seating force for a specific job application is that which is sufficient to retain the attachment, yet still allows it to release from the aluminum disc when direct contact with a foreign object is made.

6)Determine that the multi-accessory attachment is in full contact with the aluminum disc. If not in proper contact, refer to REMOVING A MULTI-ACCESSORY ATTACHMENT (not including multi-segmented, dry diamond blades) FROM THE ROTATING DISC for proper removal procedures.

7)Return the SURFACE GRINDER to its normal operating position.

8)If the machine is to be used immediately, reconnect the extension cord or SURFACE GRINDER to the power source. Determine that the ON/OFF switch located on the operator handle is in the OFF position.

DANGER

UNEXPECTED MACHINE START UP CAN RESULT IN PROPERTY DAMAGE AND/OR PERSONAL INJURY.

SFG10E ELECTRIC SURFACE GRINDER — OPERATION AND PARTS MANUAL — REV. #2 (05/28/09) — PAGE 21

Page 21
Image 21
Multiquip SFG10E manual Assembly INSTRUCTIONS/OPERATIONS