STX-SERIES — INITIAL START-UP

6.Turn the ignition key clockwise to the (start) position. The oil and charge indicator lights (Figure 9) should be on.

Figure 9. Oil and Charge Indicator Lights

In cold weather turn and hold the ignition key counter clockwise to the preheat position, wait until the

NOTE preheat indicator goes off before turning the ignition key clockwise to the start position. Two or three preheat cycles may be necessary in very cold weather.

7.Turn ignition key fully clockwise and listen for engine to start. Once engine has started release ignition key. Let engine warm for a few minutes.

8.Place the engine throttle lever (Figure 11) in the HIGH position.

9.The engine should be running at full RPM.

10.Repeat this section a few times to get fully acquainted with the engine starting procedure.

Figure 10. Engine Throttle Control Lever (High)

STX-SERIESRIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (07/16/04) — PAGE 17

Page 17
Image 17
Multiquip STX55J6 operation manual STX-SERIES Initial START-UP, Oil and Charge Indicator Lights