Multiquip STX55J6 operation manual STX-SERIES Specifications, This value includes the seat height

STX-SERIES — SPECIFICATIONS

Figure 1. STX-SERIES Dimension /Specifications

Table 2. STX-Series Specifications

STX55JDTCSL6

A–Length – in. (cm)	125 (318)
B–Width – in. (cm)	65.0 (165)
C–Height – in. (cm)1	56.0 (142)
Weight – lbs. (kgs.) Operating	2,000 (909)
Weight – lbs. (kgs.) Shipping	2500 (1137)
Sound Pressure – dBA2	97
Vibration – ft/s2 (m/ s2)3	<8.0 (2.5)
Blade Tip Speed – FPM (m/s)	1924 (9.9)
Engine – H.P.	55 John Deere, Diesel Turbocharged
Fuel Tank – gallons (liters)	12 (45)
Rotor – RPM	0 to 130
Path Width – in. (cm)	117 (297)
	AW MV 684
Hydraulic Oil4	(10W-40 hot weather)
	(10W-30 cold weather)

NOTE:

1.This value includes the seat height.

2.Sound pressure is a weighted measure. Measured at the operators ear position while the ride-on trowel is operating at full throttle on concrete in a manner most often experienced in “normal” circumstances. Sound pressure may vary depending upon the condition of the concrete. Hearing protection is always recommended.

3.The vibration level indicated is the maximum RMS (Root Mean Square) value obtained at the handle grip while operating the ride-on trowel on curing concrete in a manner

most often experienced in “normal” circumstances.Values were obtained from all three axes of motion. The values shown represent the maximum RMS value from these measurements.

4.“AW” stands for anti-wearand “MV” stands for multi- viscosity.The 68 refers to the general viscosity range and is similar to 10W-30-motor oil. It is recommended that AW MV 68 hydraulic oil be used. If this type of hydraulic oil is not available then use 10W-30 engine oil (cold weather) or 10W-40 engine oil (hot weather).

STX-SERIES • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #1 (07/16/04) — PAGE 11