set-up
Water Pump Assembly
1.Remove the water pump from the box and make sure that it is not damaged.
2.Place the pump onto the recessed area of the water tray. The pump should be oriented such that the water outlet is horizontal. See Figure 5.
3.Attach the water hose coming from the blade guard and bearing housing to the water pump.
4.Install drain plug in water tray.
5.Fill the water tray with clean fresh water. The water pump intake must always be fully covered by water. Also, keep the pump intake free of sludge, debris and other materials that may accumulate in the tray.
6.Make certain that the water hose will not come in contact with the blade or interfere with any moving parts.
BLADE
GUARD
WATER
PUMP
WATER
HOSES
DRAIN
PLUG
BEARING
HOUSING
WARNING
Disconnect the pump before attempting to handle the pump. NEVER operate pump without water in the tray.
NOTICE
The above procedure is for wet cutting applications only. NEVER dry cut with the pump connected to an AC power source. Running the pump dry will damage the pump. ALWAYSdisconnectthepump’spowercordwhendrycutting.
rear drip tray installation
Attach rear drip tray by sliding the two metal clips of the tray onto the corresponding tabs located at the rear of the saw frame. See Figure 7.
Figure 5. Water Pump and Water Tray
7. Insert the water pump power plug into the outlet receptacle | Figure 7. Rear Drip Tray | |
on the electric motor conduit box as shown in Figure 6. | ||
|
ELECTRIC MOTOR
CONDUIT BOX
POWER |
| |
PLUG |
| |
WATER | ELECTRIC WATER | |
PUMP | ||
PUMP AC | ||
| ||
| RECEPTACLE |
