Safety Information
SaW SaFeTy
danger
never operate the equipment in an explosive atmosphere or near combustible materials. An explosion or fi re could result causing severe bodily harm or even death.
WarnIng
Accidental starting can cause severe injury or death. aLWayS place the ON/OFF switch in the OFF position.
Keep hands away from moving parts at all times.
never disconnect any emergency 
or safety devices. These devices are intended for operator safety. Disconnection of these devices can cause severe injury, bodily harm or even death. Disconnection of any of these devices will void all warranties.
CauTIon
aLWayS ensure saw is securely placed on appropriate blocks or jackstands when maintenance requires elevation of the saw.
If the machine malfunctions, stop the saw immediately and secure it. Fix the problem as soon as possible.
NOTICE
aLWayS keep the machine in proper running condition.
Fix damage to machine and replace any broken parts immediately.
Make sure there is no buildup of grease, oil or debris on the machine.
aLWayS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children and unauthorized personnel.
BLade SaFeTy
WarnIng
Rotating blade can cut and crush. aLWayS keep hands and feet clear while operating
the saw.
CauTIon
never operate the saw without blade guards and covers in place. Exposure of the diamond blade must not exceed 180 degrees.
Verify the motor start switch is set to the OFF position before installing a blade.
aLWayS inspect blade before each use. The blade should exhibit no cracks, dings, or fl aws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.
NOTICE
Use proper blades and follow blade manufacturer’s recommendations. Match the blade RPM (blade shaft RPM) to the recommended blade surface feet per minute (SFPM).
Ensure the
aLWayS examine blade flanges for damage and excessive wear.
Ensure the blade is marked with an operating speed greater than the spindle speed of the saw.
Only cut the material that is specifi ed for the diamond blade. Read the specifi cation of the diamond blade to ensure the proper tool has been matched to the material being cut.
If wet cutting, ensure a WeT CuTTIng blade is being used and that the water supply system to the blade is properly functioning and being used.
do noT drop the diamond blade on ground or surface.
Ensure that the blade is mounted for proper operating direction.
Adhere to the blade manufacturer’s recommendations on handling, storage and safe usage of blades.
page 8 — TP24X TILE SAW • operation and parts manual — rev. #2 (04/12/12)
