WM-90 PLASTER/MORTAR MIXER — START-UP PROCEDURE

4.Turn the engine switch (Figure 15) to the ON position.

 

CAUTION

Preventing Drum Tipping

 

 

 

Make certain the drum lock pin (Figures 18 and 19) is placed to the RIGHT (when viewing the mixer from the towpole end) of the drum stop block which is welded to the front side of the drum. Also make sure lock pin is fully engaged (locked). This will prevent the drum from tipping.

Figure 15. Engine ON/OFF Switch

5.The main start/stop switch located on the engine cover is (Figure 16) is used to start and stop the engine. Pull this switch outward to start the engine.

Figure 18. Drum Lock Pin (Side-View)

Figure 16. Start/Stop Switch (gasoline engine)

6.Place the belt slip lever (Figure 17) in the START/ STOP (disengaged) position.

Figure 19. Drum Lock Pin (Right Position)

7. Pull the starter grip (Figure 20) lightly until you feel resistance, then pull briskly. Return the starter grip gently.

Figure 17. Belt Slip Lever

(Start/Stop Position)

Figure 20. Starter Grip

WM-90 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/10/04) — PAGE 25

Page 25
Image 25
Multiquip WM-90S manual Drum Lock Pin Side-View