WM-90 PLASTER/MORTAR MIXER — MAINTENANCE (MIXER)

Grease Fittings (Zerk) Maintenance (Electric Motor)

1.There are two grease (Figure 34) fittings at each end of the electric motor that will require lubrication. Lubricate these fittings about every 16 months.

2.Use Poleyrex EM (Exxon Mobil) or equalivant lubricant. Clean grease fitting, apply grease gun to fitting (1/2 shot). Remember too much grease or injecting grease too quickly can cause premature bearing failure. Slowly apply the recommended amount of grease, taking a miniute or so to apply.

TiresWear/Inflation

Tire inflation pressure is the most important factor in tire life. Pressure should be checked cold before operation. DO NOT bleed air from tires when they are hot. Check inflation pres- sure weekly during use to insure the maximum tire life and tread wear.

 

WARNING

Eyesight Hazard

 

 

 

ALWAYS wear safety glasses when removing or installing force fitted parts. Failure to comply may result in serious injury.

Table 9 (Tire Wear Troubleshooting) will help pinpoint the causes and solutions of tire wear problems.

Figure 34. Grease Fittings Electric Motor

TABLE 9.TIRE WEARTROUBLESHOOTING

Tires/Wheels/Lug Nuts

Tires and wheels are a very important and critical compo- nents of the trailer. When specifying or replacing the trailer wheels it is important the wheels, tires, and axle are prop- erly matched.

WARNING DamagedWheels

DO NOT attempt to repair or modify a wheel. DO NOT install an inter-tube to correct a leak through the rim. If the rim is cracked, the air pressure in the

inter-tube may cause pieces of the rim to explode (break- off) with great force and can cause serious eye or bodily injury.

WEAR PATTERN

CAUSE

Center Wear

Over Inflation

Edge Wear

Under Inflation

 

Loss of chamber

Side Wear

or overloading.

Toe Wear

Incorrect toe-in

Cupping

Out-of balance

Flat Spots

Wheel lockup &

 

tire skidding.

SOLUTION

Adjust pressure to particular load per tire manufacturer.

Adjust pressure to particular load per tire manufacturer.

Make sure load does not exceed axle rating. Align wheels.

Align wheels.

Check bearing adjust- ment and balance tires.

Avoid sudden stops when possible and adjust brakes.

PAGE 32 — WM-90 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/10/04)

Page 32
Image 32
Multiquip WM-90S manual TiresWear/Inflation, Eyesight Hazard, Tires/Wheels/Lug Nuts