MURO CH7241U manual Adjusting the screw-driving depth, Tightening the screws, Troubleshooting

￿Adjusting the screw-driving depth￿

￿Turn the screw depth adjusting dial upward to achieve more depth.

￿Turn the screw depth adjusting dial downward to achieve less depth.

￿Four clicks make an increment of 1 mm.

Approximate standard depths (0 mm deep)

Countersunk andPan-head screws flat-head screws

￿Attaching and detaching the specific connecting screws￿

Attaching

￿Place the VISROPE STRIPS in the direction shown in the figure.

Detaching

￿Hold down the connecting screw take-out button.

￿Draw out the VISROPE STRIPS.

￿Tightening the screws￿

￿ Set the screwdriver's trigger switch to the ON position.

￿ Press the lock button for continuous screw tightening.

￿ Apply and push the tool perpendicular onto the work. The CH7241 stops at the end of a stroke. The screwdriver's clutch is then activated to completely tighten up the screw.

￿Troubleshooting￿

￿Two screws fed at once, or screw jammed and stuck.

￿Hold down the connecting screw take-out button.

￿Lower the feed lever.

￿ Make sure the screws go smoothly, and draw out the

VISROPE STRIPS.