Murray 20-inch manual Assembly, WARNING The blade will rotate when the engine runs

ASSEMBLY

3.Attach the engine stop cable to the en- gine. Models with Briggs & Stratton en- gines are shown in Figure 5. Models with Tecumseh engines are shown in Figure 6.

4.Make sure the engine stop cable moves freely. If the cable does not move freely, re- peat the above steps.

CAUTION: A cable that is bent or damaged will not work correctly. Before you use the unit, replace a damaged cable.

5.Attach the cable to the handle with the cable fastener(s) as shown in Figure 4.

CAUTION: If a cable fastener is missing, a cable can be too near the muffler. Heat from the muffler can damage the cable. Before you use the unit, replace a missing cable fastener.

WARNING: The blade will rotate when the engine runs.

6.Attach the recoil–start grip and rope to the right or left side of the handle with the rope guide. Fasten with a locknut (Figure 7).

NOTE: If you cannot attach the recoil–start grip because the rope is too short, hold the engine stop lever against the handle. Slow- ly pull the recoil–start grip.

Briggs

Engine

Engine Stop

Cable

Figure 5

Tecumseh

Engine

Engine Stop

Cable

Engine

Stop Cable

Figure 6

Recoil–Start
Grip
	Locknut
	15x116
Rope Guide	Figure 7
F–040406L	14