ASSEMBLY
HOW TO ASSEMBLE THE WHEELS WITH AXLE BOLTS
1.To change the height of cut, change the position of the axle bolts on the mower housing. Make sure you assemble each axle bolt in the same hole position so that the mower will cut level.
2.Assemble the wheel to the mower hous- ing with an axle bolt, washer, and flange nut (Figure 8). To tighten, turn the axle bolt. Do not turn the flange nut.
3.If your model has hub caps, push the hub caps onto the wheels .
|
| Mower Housing | |
Hub |
|
|
|
Cap |
|
|
|
|
|
| Flange Nut |
|
|
| 15x68 |
|
| Washer | |
|
|
| 845 |
Axle | Bolt | Wheel | Figure 8 |
9x10 |
HOW TO PREPARE THE ENGINE
ENGINE DOES NOT CONTAIN
OIL OR GASOLINE
See the engine manufacturer’s instructions for the type of gasoline and oil to use. Before you use the unit, read the information on safety, op- eration, maintenance, and storage.
WARNING: Follow the engine manufacturer’s instructions for the type of gasoline and oil to use. Always use a safety gaso- line container. Do not smoke when adding gasoline to the en- gine. When inside an enclosure, do not fill with gasoline. Before you add gasoline, stop the engine. Let the engine cool for several minutes.
IMPORTANT: This unit is equipped with an internal combustion engine and must not be used on or near any unimproved forest– covered,
In the State of California the above is re- quired by law (Section 4442 of the Califor- nia Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. See an Authorized Ser- vice Center for a spark arrester for the muffler.
NOTE: Actual sustained horsepower will likely be lower due to operating limitations and environmental factors.
FINAL ASSEMBLY
Before you use the mower, check the assem- bly of the wheels, the handle, and the controls. Make sure all the fasteners are tight. Make sure the the engine stop lever works correctly.
15 |