Murray 20-inch Push manual Assembly, WARNING The blade will rotate when the engine runs

ASSEMBLY

3.Attach the engine stop cable to the en- gine. Models with Briggs & Stratton en- gines are shown in Figure 5. Models with Tecumseh engines are shown in Figure 6.

4.Make sure the engine stop cable moves freely. If the cable does not move freely, re- peat the above steps.

CAUTION: A cable that is bent or damaged will not work correctly. Before you use the unit, replace a damaged cable.

5.Attach the cable to the handle with the cable fastener(s) as shown in Figure 4.

CAUTION: If a cable fastener is missing, a cable can be too near the muffler. Heat from the muffler can damage the cable. Before you use the unit, replace a missing cable fastener.

WARNING: The blade will rotate when the engine runs.

6.Hold the engine stop lever against the handle. Slowly pull the recoil-start grip. To attach the recoil-start grip to the rope guide, twist the rope through the rope guide mounted on the right side of the handle Fasten with a locknut (Figure 7).

Briggs

Engine

Engine Stop

Cable

Figure 5

Tecumseh

Engine

Engine Stop

Cable

Engine

Stop Cable

Figure 6

Recoil-Start
Grip
	Locknut
	15x116
Rope Guide
F-050401L	14