ASSEMBLY
NOTE: In this instruction book, left and right describe the location of a part with the operator standing behind the handle.
UNPACKING INSTRUCTIONS
For shipping purposes, the mower was not fully assembled. To complete the assembly of the mower, follow the steps below.
HOW TO ASSEMBLE
THE CHUTE DEFLECTOR
WARNING: The chute deflector is necessary for your safety and protection. Do not operate the mower if the chute deflector is missing or
is not installed correctly.
1.Remove the mower from the carton.
2.Remove all packing material from the mower and the handle.
3.Attach the chute deflector to the mower housing with a bolt, washer, and nut (Figure 1). Make sure the fasteners are
tight. |
|
Bolt |
|
1x121 |
|
Washer |
|
17x37 |
|
| Nut |
| 15x116 |
Chute |
|
Deflector | Figure 1 |
|
HOW TO ASSEMBLE THE HANDLE
1.Put the ends of the lower handle into the handle slots (Figure 2).
2.Attach each side of the handle to the mower housing with a bolt, washer, spacer, and nut (Figure 2). Tighten the bolts.
3.Assemble the upper part of the handle to the lower part with the screws and lock- nuts (Figure 3).
| Lower Handle | |
Mower | Flange Nut | |
Housing | ||
15x84 | ||
| ||
Bolt |
| |
1x111 |
| |
| Spacer | |
| 671914 | |
Washer | Figure 2 | |
845 | ||
12 |
Locknut |
15x116 |
Screw |
3x136 |
Figure 3 |
