Murray 22" Self-Propelled manual Preparation, Unpacking Instructions

PREPARATION

UNPACKING INSTRUCTIONS

The mower was fully assembled at the factory. When the mower was put in the carton, the handle was put in the storage position. To put the handle in the operating position, follow the steps below.

Handle

1.Remove the mower from the carton.

2.Put the lower handle in the operating posi- tion. Make sure the lower handle is be- tween the locking tabs (Figure 1).

3.Put the upper handle in the operating position. Tighten the knobs.

CAUTION: Be careful when you fold or raise the handle. Do not damage the cables. A cable that is bent will not work correctly. Before you use the unit, re- place a bent or damaged cable.

4.To attach the recoil-start grip to the rope guide, twist the rope through the rope guide mounted on the right side of the han- dle (Figure 2).

NOTE: If you cannot attach the recoil-start grip because the rope is too short, hold the engine stop lever against the handle. Slowly pull the recoil-start grip.

	Upper Handle
Knob	Lower Handle
	Knob
	Figure 1

Recoil-Start

Grip

Rope

Guide

Figure 2

F-040411L 11