OPERATION
HOW TO START ENGINE |
| WARNING: To prevent an acci- | ||
WARNING: The blade will rotate |
| dent, make sure the drive lever is | ||
| in the DISENGAGED position. | |||
when the engine runs. |
| When the drive lever is in the EN- | ||
IMPORTANT: Before you start the engine, |
| GAGED position, do not start the | ||
| engine. | |||
operate the engine stop lever several | 6. Some models have a primer button on the | |||
times. Make sure the engine stop cable | ||||
| front or side of the engine (Figure 19). Ev- | |||
moves freely. |
| |||
| ery time you push the primer button, wait | |||
NOTE: The engine design does not include |
| |||
| two seconds. For the number of times re- | |||
a throttle control or an engine speed ad- |
| quired to push the primer button, see the | ||
justment. The engine is set at the best |
| engine manufacturer’s instructions. | ||
speed for cutting grass, bagging grass, |
|
|
| |
and for extended engine life. |
|
|
|
1.Check the oil.
2.Fill the fuel tank with regular unleaded gas- oline. Make sure the gasoline is clean. Leaded gasoline will increase deposits and shorten the life of the valves.
NOTE: Do not use gasohol or methanol. Do |
|
|
|
| |
not use premium unleaded gasoline. |
| Primer Button |
|
| |
|
|
|
| ||
WARNING: Always use a safety | Figure 19 |
| |||
|
|
| |||
gasoline container. Do not smoke |
|
|
|
| |
| NOTE: Do not use the primer button to | ||||
when adding gasoline to the fuel |
| ||||
| start a warm engine. |
|
| ||
tank. When inside an enclosure, |
|
|
| ||
do not add gasoline. Before you | 7. Stand behind the mower. Hold the engine | ||||
add gasoline, stop the engine and |
| stop lever in the OPERATING position | |||
let the engine cool for several |
| (Figure 18). |
|
| |
minutes. | 8. Electric Start Models: Turn the ignition | ||||
3. Make sure the spark plug wire is connected | |||||
| key to the START position. Use short start- | ||||
to the spark plug. |
| ing cycles (15 seconds per minute). When |
4. | Electric Start Models: Make sure the bat- | the engine starts, release the ignition key. |
If the engine will not turn over, charge the |
tery is connected to the wiring harness. | battery. See “How To Charge The Battery”. |
|
5.Make sure the drive lever is in the DISEN- GAGED position (Figure 18).
9.
Hold the engine stop lever in the operating position.
10.If the engine does not start in 5 or 6 tries, See the “Problem and Repair” Instructions.
Drive Lever
Ignition Key
Figure 18
18
HOW TO OPERATE THE MOWER
WARNING: Check the condition of the grass bag for wear or dete- rioration. If worn or damaged, re- place the parts only with ap- proved factory replacement parts. For replacement parts, see the parts list in this book.
To completely fill the grass bag, operate the engine with the throttle control in the FAST position.