Murray FT6000X92A BELT TENSION ADJUSTMENT

F-041303L

BELT TENSION ADJUSTMENT

Proper belt tension is critical to good performance. After

half hour of operation, all cables may have to be adjusted

due to initial stretch. Thereafter, check tension after every

2 hours of operation.

To increase belt tension:

1. Loosen upper jam nut. Turn nut up cable in 1/8"

increments.

2. Tighten lower jam nut.

3. Check adjustment.

This procedure can be repeated until conduit adjustment

bolts have no more adjustment left. If no more adjustment

can be made, belt may have to be replaced.

forward cable

upper jam nut

lower jam nut

1/4 stretch

beehive spring

tension spring link

Figure 4

Contents

Main Page MODEL IDENTIFICATION MODEL INFORMATION WARRANTY Thank You . . . MURRAY, INC. OWNER'S RESPONSIBILITY GENERAL PREPARATION OPERATION MAINTENANCE AND STORAGE SAFETY DECALS Transport Position Operating Position UNPACK TILLER UNPACKING AND ASSEMBLY INSTALL THE DEPTH REGULATOR LEVER FILL ENGINE CRANKCASE UNPACKING AND ASSEMBLY DRIVE SAFETY CONTROL LEVER CONTROLS BELT TENSION ADJUSTMENT ADJUSTMENTS DEPTH REGULATOR LEVER ADJUSTMENTS START-UP OPERATION Cold Starts Restarting A Warm Engine Idle Speed TILLING SHUTTING DOWN OPERATION SCHEDULE Belt Replacement SERVICING THE ROTOTILLER General Check Belt Tension Dirt Shield Check or Fill Engine Oil Engine Maintenance Change Engine Oil Dirt Shield Clean Tine Axle Shaft Check Tiller Transmission Grease PREPARE FOR STORAGE STORAGE TROUBLESHOOTING GUIDE TROUBLESHOOTING AND REPAIR PROBLEM REMEDY/ACTION Page Page Page MOTOR MOUNT & HOOD ASSEMBLY FT6000X92A Page Page MURRAY, INC. CENTRAL PARTS DISTRIBUTORS BILLIOUS, INC. BROWN & WISER, INC. CPT CANADA POWER TECHNOLOGY LIMITED FRANK EDWARDS CO.