Murray FT6000X92A manual Unpack Tiller

UNPACKING AND ASSEMBLY

UNPACK TILLER

1. Open top of carton and remove handlebar assembly.

CAUTION

Do not try to lift the rototiller from the carton.

2. Cut open end of carton and remove machine:

The right and left sides of your rototiller are determined from the operating position as you face the direction of forward travel.

a.Tines are pre-assembled at 21” width. Sharp edge of tine will be away from operator at top or face down at front of machine.(Figure 2)

b.Outside tines have two positions- wide 21” & narrow 16”. For narrow width - assemble with short side of tine holder pipe towards center of machine. For 11” width, remove outside tine sets. (Figure 1)

c.For wide width - move left tine to right side and right to left side. Assemble with long half of tine pipe towards machine. (Figure 2)

d.Remove two (2) hand knobs & bolts and slide top handle of handlebar over lower loop. Put 5/16-18 x 1-3/4” bolts thru both holes from inside out, and tighten with hand knobs.

e.Check upper and lower jam nuts for tightness. See Figure 4, Belt Tension Adjustment.

f.Add and check engine oil.

	beehive spring
	1/4” stretch
	upper jam nut
	lower jam nut
tension spring link	forward cable
	Figure 4

Narrow Tine Width Figure 1

Wide Tine Width Figure 2

upper handlebar

lower

handlebar

loop

hand knob

Figure 3

F041303L 9