Murray TM6100X5A manual Service And Adjustment, How To Adjust The Height Of The Handle

SERVICE AND ADJUSTMENT

HOW TO ADJUST

THE HEIGHT OF THE HANDLE

Use the knobs, on each side of the handle, to adjust the height of the handle.

1.Hold the handle with one hand and loosen both knobs until the ratchet teeth are dis- engaged. Do not remove the knobs. See Figure 12.

2.Move the handle up or down to the de- sired position, then align the ratchet teeth. Make sure both sides of the handle are level.

3.Tighten the knobs.

Handle

Ratchet

Teeth

Knob

Figure 12

HOW TO SET THE HEIGHT OF CUT

CAUTION: Before you set the

height of cut: stop the engine. Wait for all moving parts to stop. Allow the engine to cool and dis- connect the spark plug wire.

The height of cut can be set from 1-1/2 inches to 3 inches. Recommended cutting height for the average yard is 2”.

1.Use the T-wrench , found in the parts bag, to loosen the set screw shown in Figure 13.

2.Set the trimmer head at the desired height.

3.Tighten the set screw.

Height Of Cut Positions
Set Screw	Trimmer
	Head

Height Guide T-W rench

Figure 13

F-050204L 14