PROBLEMS?
Basic
Problem | Probable Cause | Remedy |
|
|
|
No power | Mains power supply is not fully inserted | Plug in securely |
| into mains socket |
|
| Mains power supply lead is not fully |
|
| inserted into rear socket |
|
|
|
|
No sound | Wrong connections between input | Check audio input and output lead |
| sources and the unit | connections |
| Cartridge incorrectly wired | Check cartridge wiring |
|
|
|
Sound too quiet/loud | Cartridge/turntable outputs in wrong input | Use MM input for MM cartridges; |
|
| MC input for MC cartridges. |
Sound is not precise, lacking in | Cartridge incorrectly wired | |
bass and stereo image |
| cartridge and turntable |
|
| manuals/wiring diagrams. |
| Input connector plugs not fully pushed in | Check plugs are inserted fully and |
| Output connector plugs not fully pushed in | securely |
Hum | Turntable not earthed or needs earthing | Check turntable earthing lead is |
|
| connected to earthing post on M1 |
|
| ViNL. |
| Turntable already earthed and earthing | Disconnect earthing lead from |
| further creates hum loop in system | earthing post. |
| Earth loops already in system | Investigate for earth loops |
|
| elsewhere in system. |
| Audio connector plug not fully pushed in | Insert plug securely |
| Cable fault | Check cable is connected at both |
|
| ends. |
| Unsuitable Cable | N.B. some esoteric cables have |
| (e.g. cable grounds not connected) | internal wiring intentionally |
|
| disconnected/modified. For best |
|
| results on all inputs AND outputs, |
|
| please use good quality screened |
|
| coax; fully connected |
|
| signal, |
Plop or click heard in speakers | High gain of M1 ViNL, amplifying normal | Not a fault. It is recommended that |
when switching on or off or | circuit transients. | the volume level on amplifier is |
changing options |
| turned down if switching the M1 |
|
| ViNL on or off; or pressing option |
|
| switches whilst connected. |
Distorted sound | Cartridge and/or tone arm not aligned | Carefully follow turntable |
| properly | instructions to correctly |
|
| tone arm and cartridge. |
| Cartridge fault or worn needle | Replace needle or cartridge. |
| Dirt on record | Clean dust and dirt from record |
|
|
|
Distorted and loud sound | Line outputs of M1 ViNL plugged into | Use LINE level inputs only, e.g. an |
| PHONO amplifier inputs of following | AUX input, for the outputs of the M1 |
| amplifier | ViNL. |
|
|
|
If none of these actions affect a cure, please contact the dealer, or an authorised Musical Fidelity service agent. Remember; never open the case of the M1 ViNL, as this will invalidate the guarantee.
M1 ViNL manual issue 2.doc2 | Page 10 of 12 |